Boat LED Underwater Lights

Viking boat lights     

SV10 HID 150 Watt

The Sea Vision SV 10 model offers the largest aperture of all the fiberglass models giving maximum light output from the 150 watt HID metal halide lamp. It can be installed in the transom or the hull and is suitable for boats with 110-230 volt AC power, including sportfish, yachts and cruisers. The vessel must be hauled out for installation although lamp change and any maintenance can be done in the water from within the hull.

  • The 150W, HID, gas discharge lamp used in this light is not an instant re-strike lamp. This means that it must be allowed to cool for approximately 10 to 20 minutes after being shut off before being restarted. HID lamps generally require approximately 2 minutes to reach full brightness and should be left on for a minimum of 10 minutes. Failure to do so may cause the lamp to flicker when it is turned on the next time.
  • Depending upon water clarity conditions, the light beam can reach up to 30 meters (100 feet).


Lamp: Life Length: Kelvin Color Temp: Glass Lens: Thickness: Power Supply: Casing Material Dimensions: Weight: Ballast: Installation: Angles Available:
150 watt HID metal halide 3,000 hours plus 7500
Lumens: 12,000
Borosilicate Glass 12.7mm / 0.5” 120 VAC 50/60Hz input - running current 1.33 amps 230 VAC 50/60Hz input - running current 0.59 amps Marine Bronze / Marine Aluminum
130 mm (5.12”) x 203 mm (8.0”)
3.5 Kgs /8 lbs SV18 120 VAC 50/60Hz 230 VAC 50/60 Hz Recommended at minimum 10" (250mm) below light load waterline between 3 - 8 feet (1-2.5 meters) apart. (100mm) 4” cut out hole Flush

  • Underwater Lights USA, LLC takes pride in providing well designed, high quality and thoroughly tested lights that allow you to “enhance your boating experience”. These lights can be installed in your vessel for aesthetics, to attract fish, for security and safety.
  • The light and electrical cabling should be visually inspected for proper operating condition every six months.
  • Marine growth should be removed from the glass using a soft brush to allow both heat and illumination to exit the light.
  • The body of the light must be electrically joined to the vessels grounding and cathodic protection system. Failure to do so may cause light corrosion cause light corrosion.
  • Warranty

    Underwater Lights ® USA, LLC warrants this light to be free from defects in workmanship and materials for a period of two years from the date of original purchase. Further, misuse, abuse, impro per installation, neglect, improper shipping, damage caused by disasters such as fire, flood and lightning, unauthorized repair or modifications will void said warranty. Should your light prove defective during the warranty period, promptly contact Underwater Lights ® USA, LLC for an RMA number and then return the light freight prepaid with the RMA number clearly marked on the outside of the shipping container.